Allied-telesis AT-3726 Manuel d'utilisateur télécharger pdf (Page 28)

Installing the Switch

2-10

Installing a

Media

Dependent

Adapter

To install an MDA, do the following:

1. Disconnect the switch’s power cord.

2. Unscrew the three Phillips head screws on the blank faceplate and

save the faceplate and screws for future use.

Caution

Make sure the MDA blank panel is attached to the unit if the MDA slot

is vacant.

3. The standoff on the MDA serves as a guide to slide the MDA correctly

into its slot so that the MDA’s 50-pin female connector attaches

securely to the 50-pin male connector on the main board. See

Figure 2-4 and Figure 2-5 when performing the next step.

4. Slide the MDA into its empty slot making sure that the standoff is

aligned properly prior to connecting the 50-pin connector.

5. Attach the female 50-pin female connector to its counterpart.

Figure 2-4 Guiding the MDA (AT-3701) Standoff into Its Slot

3701

100BASE-TX

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 59 60

Pas de commentaire

Allied-telesis AT-3726 Manuel d'utilisateur Page 28