Allied Telesis AT-8948 Spécifications Page 160

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 174
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 159
ICMP Router Discovery Advertisements (CR00010614) 160
Version 291-18
C613-10488-00 REV Q
Advertisement interval
The router advertisement interval is the time between router advertisements. For the first few advertisements sent from an interface (up to 3), the router or
switch sends the router advertisements at intervals of at most 16 seconds. After these initial transmissions, it sends router advertisements at random intervals
between the minimum and maximum intervals that the user configures, to reduce the probability of synchronization with the advertisements from other
routers on the same link. By default the minimum is 450 seconds (7.5 minutes), and the maximum is 600 seconds (10 minutes).
Preference level
The preference level is the preference of the advertised address as a default router address relative to other router addresses on the same subnet. By default, all
routers and layer 3 switches have the same preference level, zero. While it is entered as a decimal from -2147483648 to 2147483647, it is encoded in router
advertisements as a twos-complement hex integer from 0x8000000 to 0x7fffffff. A higher preference level is preferred over a lower value.
Lifetime
The lifetime of a router advertisement is how long the information in the advertisement is valid. By default, the lifetime of all advertisements is 1800 seconds (30
minutes).
Configuration procedure
Do the following to configure the router or switch to send router advertisements.
1. Set the physical interface to advertise.
For each physical interface that is to send advertisements, add the interface. In most cases the default advertising parameters work well, but you can
change them if required. By default, the router or switch sends advertisements every 7.5 to 10 minutes, with a lifetime of 30 minutes. These settings are
likely to work in most situations and not cause extra traffic, even if there are several routers or switches on the LAN. If you change these settings, keep the
following proportions:
lifetime=3 x maxadvertisementinterval
minadvertisementinverval=0.75 x maxadvertisementinterval
To change these settings, use one of the commands:
add ip advertise interface=interface [advertisementaddress={all|limited}] [maxadvertisementinterval=4..1800]
[minadvertisementinterval=3..maxadvertisementinterval] [lifetime=maxadvertisementinterval..9000]
set ip advertise interface=interface [advertisementaddress={all|limited}] [maxadvertisementinterval=4..1800]
[minadvertisementinterval=3..maxadvertisementinterval] [lifetime=maxadvertisementinterval..9000]
Vue de la page 159
1 2 ... 155 156 157 158 159 160 161 162 163 164 165 ... 173 174

Commentaires sur ces manuels

Pas de commentaire